使用方法：Usage Method ● 本品為濃溶液。使用步驟如下：This is concentrated solution, usage method as follows 1、用布或海綿蘸上少許本品在玻璃發霉的地方（空氣面）擦拭，如果發霉情況較為嚴重可以來回擦洗1-3分鐘，然后用清水沖洗干凈、晾干；使玻璃表面光亮如新，不掛水，不起霧。 1.Use a cloth or a sponge, affix some of the liquid, wipe off on the moldy glass. If the glass is too moldy, you can wipe off on it for about 1 to 3 minutes, then use some water to wash the glass. After airing, the glass will be as bright as a new one. It will neither t attach water, no fogging. 2、或者根據玻璃發霉的位置、嚴重程度，將需要處理的玻璃浸泡在適量本品中，3-5分鐘后取出用清水沖洗干凈，擦干。 2.According to the moldy place of the glass as well as the order of severity, you could put the moldy place into some this liquid, after 3 to 5 minutes, take it out, and then airing. 3、使用過本品的玻璃需要用清水再次沖洗干凈，防止本品長時間殘留于玻璃表面，對玻璃造成傷害。 3.You should clean the glass with water after using this liquid in case that after a long time, the liquid left on the glass will do harm the glass. ● 對于發霉程度極輕的玻璃制品，可以將本品稀釋使用，步驟如下： According to the slightly moldy glass, you could dilute this liquid, method as follows, 1、  推薦稀釋比例為1：1（本品：水），混勻后裝入噴壺，噴于玻璃表面，可用軟布或海綿配合擦拭，然后用清水沖洗干凈。 1.Propotion:1:1(water: this liquid), after mixed, pull into a watering can, spurt on the face of the moldy glass. You could also use a soft cloth or a sponge to wipe off the glass. Then clean it with pure water. 2、可比較幾種稀釋比例的使用效果，找到較佳使用濃度。建議較多稀釋至1：3（本品：水），以保證使用效果。 2.You could have a comparison of all the different proportions, and find out the best using effect. We suggest a limited proportion of 1:3(this liquid:water:) to ensure the using effect.